Iei-integration PPC-WIDS-51xxA-G41 Manuel d'utilisateur télécharger pdf (Page 86)

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC

Page 74

The IDE Configuration menu (BIOS Menu 4) allows changes to the configurations for the

IDE devices installed in the system. If an IDE device is detected and one of the above

listed four BIOS configuration options are selected, the IDE configuration options shown in

Section

5.3.2.1 appear.

5.3.2.1 IDE Master, IDE Slave

Use the IDE Master and IDE Slave configuration menu to view both primary and

secondary IDE device details and configure the IDE devices connected to the system.

BIOS SETUP UTILITY

Main Advanced PCIPNP Boot Security Chipset Exit

Primary IDE Master

⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯

Device :Not Detected

Type [Auto]

LBA/Large Mode [Auto]

Block (Multi-Sector Transfer) [Auto]

PIO Mode [Auto]

DMA Mode [Auto]

S.M.A.R.T. [Auto]

32Bit Data Transfer [Enabled]



Select Screen

↑ ↓ Select Item

Enter Go to SubScreen

F1 General Help

F10 Save and Exit

ESC Exit

BIOS Menu 5: IDE Master and IDE Slave Configuration

 Auto-Detected Drive Parameters

The “grayed-out” items in the left frame are IDE disk drive parameters automatically

detected from the firmware of the selected IDE disk drive. The drive parameters are listed

as follows:

 Device: Lists the device type (e.g. hard disk, CD-ROM etc.)

 Type: Indicates the type of devices a user can manually select

 Vendor: Lists the device manufacturer

 Size: List the storage capacity of the device.

 LBA Mode: Indicates whether the LBA (Logical Block Addressing) is a method

of addressing data on a disk drive is supported or not.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 151 152

Pas de commentaire

Iei-integration PPC-WIDS-51xxA-G41 Manuel d'utilisateur Page 86