Iei-integration UPC-12AH_GM45 v1.00 Manuel d'utilisateur télécharger pdf (Page 65)

UPC-12A/GM45 Panel PC

Page 53

Figure 4-19: Suggested Panel Cut Out Size for UPC-12A/GM45 (Unit: mm)

Step 3: Slide the flat panel computer through the previously cut hole. The chassis at the

rear of the flat panel should slide easily through the hole. Only stop sliding the

panel through the hole when the back of the front aluminum frame is flush

against the panel.

Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of

the chassis, behind the aluminum frame. There are a total of 6 panel mounting

clamps for UPC-12A/GM45.

Figure 4-20: Panel Mounting Clamp Slots (Side View)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 146 147

Pas de commentaire

Iei-integration UPC-12AH_GM45 v1.00 Manuel d'utilisateur Page 65