Iei-integration ACT-457A Manuel d'utilisateur télécharger pdf (Page 32)

ACT-457A Panel PC

Page 24

NOTE:

When purchasing the arm please ensure it has a 75 mm x 75 mm

mounting hole pattern. Only this mounting size will support the

ACT-457A.

Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel

PC onto the interface pad of the mounting arm.

Step 3: Align the retention screw holes on the mounting arm interface with those in the

flat panel PC. The ACT-457A arm mount retention screw holes are shown in

Figure 2-13.

Figure 2-13: ACT-457A Arm Mounting Retention Screw Holes

Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 66 67

Pas de commentaire

Iei-integration ACT-457A Manuel d'utilisateur Page 32