Iei-integration AFL-056A-LX v1.02 Manuel d'utilisateur télécharger pdf (Page 37)

AFOLUX LX Panel PC

Page 24

Step 1: Unpack the flat panel PC

Step 2: Install CF card

Step 3: Mount the flat panel PC

Step 4: Connect peripheral devices to the bottom panel of the flat panel PC

Step 5: Configure the systemStep 0:

3.4 Unpacking

To unpack the flat panel PC, follow the steps below:

WARNING!

The front side LCD screen has a protective plastic cover stuck to the

screen. Only remove the plastic cover after the flat panel PC has been

properly installed. This ensures the screen is protected during the

installation process.

Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the

external (second) box.

Step 2: Open the external (second) box.

Step 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the

internal (first) box.

Step 4: Lift the monitor out of the boxes.

Step 5: Remove both polystyrene ends, one from each side.

Step 6: Pull the plastic cover off the flat panel PC.

Step 7: Make sure all the components listed in the packing list are present. Step 0:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 115 116

Pas de commentaire

Iei-integration AFL-056A-LX v1.02 Manuel d'utilisateur Page 37