Iei-integration AFL-15A-N270 v2.10 Manuel d'utilisateur télécharger pdf (Page 43)

AFOLUX AFL-15A-N270 Panel PC

Page 43

standby mode. Remote power control is perfect for advertising applications since the

broadcasting time for each panel PC can be set individually and controlled remotely. Other

possible application includes

 Security surveillance

 Point-of-Sale (POS)

 Advertising terminal

4.9 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

The following jumpers can be found on the motherboard installed in the AFL-15A-N270.

Before the AFL-15A-N270 is installed, the jumpers must be set in accordance with the

desired configuration. The jumpers on the AFL-15A-N270 motherboard are listed in

Table

4-1.

Description Label Type

CF card setup JCF1 2-pin header

Clear CMOS J_COMS1 3-pin header

COM1 Pin 9 setting JP6 6-pin header

COM3 Pin 9 setting JP7 6-pin header

COM3 RX RS-232/422/485 select JP8 8-pin header

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 158 159

Pas de commentaire

Iei-integration AFL-15A-N270 v2.10 Manuel d'utilisateur Page 43