Iei-integration AFL-F08A v2.40 Manuel d'utilisateur télécharger pdf (Page 44)

AFL-F08A-N270 Panel PC

Page 29

Figure 3-13: CompactFlash® Setup Jumper Location

3.8 Mounting the System

WARNING!

When mounting the system onto an arm, onto the wall or onto a panel,

it is better to have more than one person to help with the installation to

make sure the panel PC does not fall down and get damaged.

Available mounting methods are listed in the subsections below.

3.8.1 Wall Mounting

To mount the system onto the wall, please follow the steps below.

Step 1: Select the location on the wall for the wall-mounting bracket.

Step 2: Carefully mark the locations of the four screw holes in the bracket on the wall.

Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention

screws.

Step 4: Align the wall-mounting bracket screw holes with the pilot holes.

Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into

the four pilot holes and tightening them (

77Figure 3-14).

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 178 179

Pas de commentaire

Iei-integration AFL-F08A v2.40 Manuel d'utilisateur Page 44