Iei-integration AFL-W19A_W19B_17D_W15A-N270 v1.06 Manuel d'utilisateur télécharger pdf (Page 30)

AFL-W19A/W19B/17D/W15A-N270 Panel PC

Page 18

Figure 2–7: CompactFlash® Install

Step 3: Replace the cover and screws.Step 0:

2.5 Jumper Settings

NOTE:

A jumper is a metal bridge used to

close an electrical circuit. It consists of

two or three metal pins and a small

metal clip (often protected by a plastic

cover) that slides over the pins to

connect them. To CLOSE/SHORT a

jumper means connecting the pins of

the jumper with the plastic clip and to OPEN a jumper means removing

the plastic clip from a jumper.

The following jumpers can be found on the motherboard installed in the

AFL-W19A/W19B/17D/W15A-N270. Before the AFL-W19A/W19B/17D/W15A-N270 is

installed, the jumpers must be set in accordance with the desired configuration. The

jumpers on the AFL-W19A/W19B/17D/W15A-N270 motherboard are listed in

Table 2-2.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 124 125

Pas de commentaire

Iei-integration AFL-W19A_W19B_17D_W15A-N270 v1.06 Manuel d'utilisateur Page 30