Iei-integration AFL2-10A-N28 Manuel d'utilisateur télécharger pdf (Page 51)

AFL2-10A-N28 Panel PC

Page 34

Step 8: Once the flat bezel panel PC with the attached rack/cabinet bracket has been

properly inserted into the rack or cabinet, secure the front of the rack/cabinet

bracket to the front of the rack or cabinet (

Figure 3-19).

3.11.4 Arm Mounting

The AFL2-10A-N28 is VESA (Video Electronics Standards Association) compliant and can

be mounted on an arm with a 75 mm interface pad. To mount the AFL2-10A-N28 on an

arm, please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

NOTE:

When purchasing the arm please ensure that it is VESA compliant and that

the arm has a 75 mm interface pad. If the mounting arm is not VESA

compliant it cannot be used to support the AFL2-10A-N28 flat bezel panel

PC.

Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat bezel

panel PC onto the interface pad of the mounting arm.

Step 3: Align the retention screw holes on the mounting arm interface with those in the

flat bezel panel PC (

Figure 3-20).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 202 203

Pas de commentaire

Iei-integration AFL2-10A-N28 Manuel d'utilisateur Page 51