Iei-integration AFL2-12A-D525 Manuel d'utilisateur télécharger pdf (Page 42)

AFL2-12A-D525 Series Panel PC

Page 42

 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground

themselves first and wear and anti-static wristband.

4.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the flat bezel panel PC

Step 2: Install an HDD

Step 3: Configure the system

Step 4: Connect peripheral devices to the bottom panel of the flat bezel panel PC

Step 5: Mount the flat bezel panel PC Step 0:

4.4 HDD Installation

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To install the HDD into the AFL2-12A-D525, please follow the steps below:

Step 1: Remove two (2) retention screws from the HDD cover (

Figure 4-1).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 179 180

Pas de commentaire

Iei-integration AFL2-12A-D525 Manuel d'utilisateur Page 42