Iei-integration AFL2-12A-HM65 v1.12 Manuel d'utilisateur télécharger pdf (Page 48)

AFL2-12A-HM65 Series Panel PC

Page 34

Figure 4-9: Cutout Dimensions

Step 3: Slide the flat panel PC through the hole until the frame is flush against the panel.

Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on

the rear of the panel PC.

Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting

the four retention screws into the VESA mounting holes (

Figure 4-10

Step 6: Insert the panel mounting clamps into the pre-formed holes along the two edges

of the panel mounting brackets (

Figure 4-10

). There are a total of 4 panel

mounting clamps for AFL2-12A-HM65.

Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel

(

Figure 4-10

). Step 7:

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 192 193

Pas de commentaire

Iei-integration AFL2-12A-HM65 v1.12 Manuel d'utilisateur Page 48