Iei-integration AFL2-17A-H61 v1.11 Manuel d'utilisateur télécharger pdf (Page 83)

AFL2-17A/AB-H61

Page 64

5.13.3 Stand Mounting

To mount the AFL2-17A/AB-H61 using the stand mounting kit, please follow the steps

below.

Step 1: Locate the screw holes on the rear of the AFL2-17A/AB-H61. This is where the

bracket will be attached. (Figure 5-20)

Figure 5-20: Mounting screw location

Step 2: Align the bracket with the screw holes.

Step 3: To secure the bracket to the AFL2-17A/AB-H61, insert the retention screws into

the screw holes and tighten them. Step 0:

5.13.4 Arm Mounting

The AFL2-17A/AB-H61 is VESA (Video Electronics Standards Association) compliant and

can be mounted on an arm with a 100mm interface pad. To mount the AFL2-17A/AB-H61

on an arm, please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 274 275

Pas de commentaire

Iei-integration AFL2-17A-H61 v1.11 Manuel d'utilisateur Page 83