Iei-integration AFL2-W10A-N28 Manuel d'utilisateur télécharger pdf (Page 55)

AFL2-W10A-N28 Panel PC

Page 37

Step 1: Carefully mark the locations of the four V-Stand screw holes on the mounting

area. Drill four pilot holes at the marked locations for the V-Stand retention

screws.

Figure 3-23: Drill Pilot Holes for V-Stand

Step 2: Align the screw holes on the V-Stand with the VESA mount screw holes on the

system rear panel.

Step 3: Insert the four VESA mount screws into the four screw holes on the system rear

panel. Adjust the V-Stand to a proper position.

Step 4: Tighten until the screw shank is secured against the rear panel.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 205 206

Pas de commentaire

Iei-integration AFL2-W10A-N28 Manuel d'utilisateur Page 55