Iei-integration AFL2-W15A-N270 v2.00 Manuel d'utilisateur télécharger pdf (Page 43)

AFL2-W15A-N270 Panel PC

Page 31

Figure 2-19: Cutout

Step 3: Slide the flat panel PC through the hole until the aluminum frame is flush against

the panel.

Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on

the rear of the panel PC.

Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting

the four retention screws into the VESA mounting holes (

Figure 2-20



Step 6: Insert the panel mounting clamps into the pre-formed holes along the two edges

of the panel mounting brackets (

Figure 2-20



). There are a total of 4 panel

mounting clamps for the AFL2-W15A-N270.

Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel

(

Figure 2-20



1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 140 141

Pas de commentaire

Iei-integration AFL2-W15A-N270 v2.00 Manuel d'utilisateur Page 43