Iei-integration S12A v1.12 Manuel d'utilisateur télécharger pdf (Page 27)

SAILORPC-12A Panel PC

Page 17

Step 4: Make sure the outer seal is seated properly, then replace the cover.Step 0:

3.4 Jumper Settings

NOTE:

A jumper is a metal bridge that is used

to close an electrical circuit. It consists

of two metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them.

To CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

3.4.1 Reset CMOS

Jumper Label: JP11

Jumper Type:

3-pin header

Jumper Settings:

See

Table 3-1

This jumper will reset the CMOS. Turn off the system. Set the jumper to "Reset CMOS",

turn on the power for a few seconds. Turn off the system. Set the jumper back to "Normal".

Pin Description

1-2 Normal

2-3 Reset CMOS

Table 3-1: Reset CMOS

3.4.2 AT/ATX Power

Jumper Label: JP10

Jumper Type:

2-pin header

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 109 110

Pas de commentaire

Iei-integration S12A v1.12 Manuel d'utilisateur Page 27