Iei-integration ICE-DB-9S Manuel d'utilisateur télécharger pdf (Page 101)

ICE Module

Page 88

5.3.1 Four-Layer Stack-up

Figure 5-1 below is an example of a four layer stack-up. Layers L1 and L4 are used for

signal routing. Layers L2 and L3 are used for solid ground and power planes

respectively. Microstrips on Layers 1 and 4 reference ground and power planes on

Layers 2 and 3 respectively. In some cases, it may be advantageous to swap the GND

and PWR planes. This allows Layer 4 to be GND referenced. Layer 4 is clear of parts

and may be the preferred primary routing layer.

Figure 5-1: Four Layers Stack

5.3.2 Six-Layer Stack-up

Figure 5-2 below is an example of a six layer stack-up. Layers L1, L3, L4 and L6 are

used for signal-routing. Layers L2 and L5 are power and ground planes respectively.

Microstrips on Layers 1 and 6 reference solid ground and power planes on Layers 2

and 5 respectively. Inner Layers 3 and 4 are asymmetric striplines that are referenced

to planes on Layers 2 and 5.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 158 159

Pas de commentaire

Iei-integration ICE-DB-9S Manuel d'utilisateur Page 101