Iei-integration WAFER-LX v1.0 Manuel d'utilisateur télécharger pdf (Page 61)

WAFER-LX User Manual

3.4 Installation

Figure

3-6 Soldering Side Sockets

IDE Disk Drive and CDROM Connector

The WAFER-LX provides 1 IDE channel which allows the connection to two Enhanced Integrated

Device Electronics hard disk drives or CD/DVD-ROM. The IDE controller is attached to a PCI

interface. The advanced IDE controller supports PIO mode 3, mode 4 and up to UDMA/100 in

transfer speed.

Connecting Hard Disk Drives

IDE bus devices are daisy-chained using a standard 44-pin IDE cable. Connection is made by

connecting one end of the cable to the CN30 IDE connector. The connector has a keyed pin

which prevents you from inserting the connector in a wrong direction. The read wire corresponds

to pin 1 on the connector.

Plug the other end of the cable into the Enhanced IDE hard drive, with pin 1 on the cable

corresponding to pin 1 on the hard drive.

Note that when connecting two IDE disk drives you will have to configure one as the master and

the other the slave. The configuration is done by setting the jumpers on the disk drives.

3-8

IEI

Technology, Corp.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 143 144

Pas de commentaire

Iei-integration WAFER-LX v1.0 Manuel d'utilisateur Page 61