Iei-integration DM_Series v1.14 Manuel d'utilisateur télécharger pdf (Page 174)

DM Series Industrial Monitor

Page 174

8.1 Gasket Replacement

A gasket used for a long time may gradually lose its ability to protect the monitor from

fluids and vapors; scratches or dirt may also accumulate. It is recommended that the

gasket be replaced yearly.

NOTE:

If the monitor is mounted vertically, first remove it and place it on a flat, level

surface with the display screen facing down before changing the gasket.

Step 1: Remove the old gasket from the sides of the monitor.

Step 2: Attach the new gasket to the monitor. Make sure the gasket fits precisely into the

groove along the edges of the monitor’s front panel (

Figure 8-1). Step 0:

Figure 8-1: Gasket Replacement

NOTE:

Compliance with the IP 65 standard depends on correct installation of the

gasket. Be sure to check that the gasket is properly installed after changing it.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 197 198

Pas de commentaire

Iei-integration DM_Series v1.14 Manuel d'utilisateur Page 174