Iei-integration AFL-F08A v2.10 Manuel d'utilisateur télécharger pdf (Page 44)

AFL-F08A-N270 Panel PC

Page 32

Step 3: Align the retention screw holes on the mounting arm interface with those in the

flat panel PC.

Figure 3-17: Arm Mounting Retention Screw Holes

Step 4: Secure the system to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel PC.

Step 0:

3.8.4 Cabinet and Rack Installation

The AFL-F08A-N270 can be installed into a cabinet or rack. The installation procedures

are similar to the panel mounting installation. To do this, please follow the steps below:

NOTE:

When purchasing the cabinet/rack installation bracket, make sure it is

compatible with both the AFL-F08A-N270 and the rack/cabinet into

which the AFL-F08A-N270 is installed.

Step 1: Slide the rear chassis of the AFL-F08A-N270 through the rack/cabinet bracket

until the aluminum frame is flush against the front of the bracket (

537H537HFigure 3-18).

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 142 143

Pas de commentaire

Iei-integration AFL-F08A v2.10 Manuel d'utilisateur Page 44