Iei-integration AFL-F08A v2.10 Manuel d'utilisateur télécharger pdf (Page 78)

AFL-F08A-N270 Panel PC

Page 66

NOTE: Make sure the selected COM port is enabled through the Super I/O configuration

menu.

Î Base Address, IRQ [2F8h,3]

The Base Address, IRQ option cannot be configured and only shows the interrupt

address of the serial port listed above.

Î Serial Port Mode [115200 8,n,1]

Use the Serial Port Mode option to select baud rate through which the console redirection

is made. The following configuration options are available

 115200 8,n,1 D

EFAULT

 57600 8,n,1

 38400 8,n,1

 19200 8,n,1

 09600 8,n,1

NOTE:

Identical baud rate setting musts be set on the host (a management

computer running a terminal software) and the slave

Î Redirection After BIOS POST [Always]

Use the Redirection After BIOS POST option to specify when console redirection should

occur.

Disabled

The console is not redirected after POST

Boot Loader

Redirection is active during POST and during Boot

Loader

Always DEFAULT

Redirection is always active (Some OSes may not

work if set to Always)

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 142 143

Pas de commentaire

Iei-integration AFL-F08A v2.10 Manuel d'utilisateur Page 78