Iei-integration AFL-W10A-N270 v1.00 Manuel d'utilisateur télécharger pdf (Page 30)

AFL-W10A-N270 User Manual

Page 30

2.5 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

The following jumpers can be found on the motherboard installed in the AFL-W10A-N270.

Before the panel PC is installed, the jumpers must be set in accordance with the desired

configuration. The jumpers on the AFL-W10A-N270 motherboard are listed in

Table 2-1.

Description Label Type

Clear CMOS J_COMS1 2-pin header

COM1 Pin 9 setting JP8 10-pin header

COM3 Pin 9 setting JP10 6-pin header

COM3 RX RS-232/422/485 select JP9 8-pin header

COM3 TX RS-422/485 select JP11 6-pin header

COM3 RS-232/422/485 select JP6 12-pin header

Table 2-1: Jumpers

2.5.1 Access the Jumpers

To access the jumpers, remove the back panel. To remove the back panel, please refer to

Section 2.2.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 112 113

Pas de commentaire

Iei-integration AFL-W10A-N270 v1.00 Manuel d'utilisateur Page 30