Iei-integration AFL-W10A-N270 v1.00 Manuel d'utilisateur télécharger pdf (Page 54)

AFL-W10A-N270 User Manual

Page 54

3.4 Memory Module Replacement

The panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory module is

fail, follow the instructions below to replace the memory module.

Step 7: Remove the aluminum back cover. See Section 3.3 above.

Step 8: Locate the DDR2 SO-DIMM on the motherboard (

Figure 3-4).

Figure 3-4:AFL-W10A-N270 SO-DIMM Socket Location

Step 9: Remove the DDR memory module by pulling both the spring retainer clips

outward from the socket.

Step 10: Grasp the DDR memory module by the edges and carefully pull it out of the

socket.

Step 11: Install the new DDR memory module by pushing it into the socket at an angle

(

Figure 3-5).

Step 12: Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (

Figure 3-5).

Step 13: Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.Step 0:

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 112 113

Pas de commentaire

Iei-integration AFL-W10A-N270 v1.00 Manuel d'utilisateur Page 54